Store Memory Settings
(Displayed on Configure Menu)
To store memory settings, do the following:
1. Be sure the ignition is either on, in accessory mode,
or in RAP. The vehicle must be stopped and/or the
shift lever must be in PARK (P).
2. Press any button on the appropriate keyless access
transmitter to identify yourself as Driver 1 or Driver 2.
The numbers on the back of the keyless access
transmitters correspond to the driver number.
3. Press the CONFIG hard key.
4. Adjust your settings for the driver’s seat, the outside
mirrors, and the steering column to a comfortable
driving position or exit position.
5. Push and hold either the Driver 1 or Driver 2 screen
buttons to store the driving positions. Push and hold
the Exit screen button to store the exit position.
A beep will sound to confirm that the driver settings
are stored.
Two beeps will sound to confirm that the exit settings
are stored.
The memory settings are now programmed. Any
changes that are made to the Head-Up Display
(HUD), navigation system, and climate controls
while driving will be automatically stored when
then ignition is turned off.
Displayed on Configure Menu
5-19
To Next Page
Loading...
