Front Seats
Power Seats
The power seat controls
are located on the
outboard side of the seat
cushions.
• Move the seat forward or rearward by sliding the
horizontal control forward or rearward.
• Raise or lower the front part of the seat cushion by
moving the front of the horizontal control up or down.
• Raise or lower the rear part of the seat cushion by
moving the rear of the horizontal control up or down.
• Raise or lower the entire seat by moving the entire
horizontal control up or down.
• Use the vertical control to recline the seatback.
See Power Reclining Seatbacks on page 1-4.
Power Lumbar
The driver’s and
passenger’s seatback
lumbar support switches
are located on the
outboard sides of the
seats.
Use the power seat controls first to get the proper
position, then continue with the lumbar adjustment.
Use the top lumbar switch to adjust support to the
middle seatback and the bottom lumbar switch to adjust
support to the lower seatback. Press the front of the
switch to increase support and the rear of the switch to
decrease support.
Keep in mind that as your seating position changes,
as it may during long trips, so should the position of your
lumbar support. Adjust the seat as needed.
1-2
To Next Page
Loading...
Need help?
General
