Cadillac ATS 2017 - Bluetooth (Voice Recognition)

Cadillac ATS/ATS-V Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
9956102) - 2017 - crc - 5/11/16
INFOTAINMENT SYSTEM 191
If not initially in the phone
application, from the Home Page, turn
the MENU knob, then press to select
the PHONE screen button. From the
PHONE main menu, turn the MENU
knob to highlight “Active Call” and
press to select.
Bluetooth (Voice
Recognition)
Using Voice Recognition
To use voice recognition, press g on
the steering wheel. Use the commands
below for the various voice features.
For additional information, say “Help”
while you are in a voice
recognition menu.
Pairing
A Bluetooth-enabled cell phone must
be paired to the Bluetooth system and
then connected to the vehicle before it
can be used. See your cell phone
manufacturer's user guide for
Bluetooth functions before pairing the
cell phone. If a Bluetooth phone is not
connected, calls can be made using
OnStar Hands-Free Calling,
if available. See OnStar Over view 0 398.
Pairing a Phone
1. Press
g. The system responds
“Ready,” followed by a tone.
2. Say “Bluetooth.”
3. Say “Pair.” The system responds
with instructions and a four-digit
Personal Identification Number
(PIN). The PIN is used in Step 5.
4. Start the pairing process on the
cell phone that you want to pair.
For help with this process, see
your cell phone manufacturer's
user guide.
5. Locate the device named “Your
Vehicle” in the list on the cell
phone. Follow the instructions
on the cell phone to enter the
PIN provided in Step 3. The
system may respond with a six
digit code to be confirmed on the
cell phone (instead of entering a
four-digit code). Check that the
same digits are shown on the cell
phone and say "Yes" to confirm.
Select Confirm on the cell phone
as well. After the PIN is
successfully entered, the system
prompts you to provide a name
for the paired cell phone. This
name will be used to indicate
which phones are paired and
connected to the vehicle. The
system responds with “<Phone
name> has been successfully
paired” after the pairing process
is complete.
6. Repeat Steps 1−5 to pair
additional phones.
Listing All Paired and Connected
Phones
The system can list all cell phones
paired to it. If a paired cell phone is
also connected to the vehicle, the
system responds with “is connected”
after that phone name.
1. Press
g. The system responds
“Ready,” followed by a tone.
2. Say “Bluetooth.”
3. Say “List.”
Deleting a Paired Phone
If the phone name to delete is
unknown, see “Listing All Paired and
Connected Phones.”