Cadillac BLS - Page 151

151Starting and driving
StabiliTrak
®
OFF
in the main instrument panel illumi-
nates when
• the system has been switched off manu-
ally, speed must be below 60 km/h.
• a fault has arisen in the ABS/StabiliTrak
®
system.
• there is a fault in the system, and at the
same time the following message is
shown on the DIC:
Turning the StabiliTrak
®
system
off temporarily
The StabiliTrak
®
system is switched on
automatically when the engine is started.
It may be necessary to switch off the system
if the car has become bogged down, for
instance.
The StabiliTrak
®
system is always active
during braking, even if it has been switched
off, but if a fault arises in the ABS/Stabi-
liTrak
®
system the StabiliTrak
®
system is
disengaged.
The cruise control system 3 is disengaged
when theStabiliTrak
®®
system is operative.
Disengage the system in Settings.
1Select Settings using the steering
wheel buttons, or .
2 Hold the SET button depressed until a
chime sounds.
3Select ESP (StabiliTrak
®
).
4 Press the SET button.
5Select ON or OFF.
End by pressing the SET button.
Go back/undo using the CLR button.
Stability control failure.
Contact service.
NOTICE
Chassis modifications, such as change of
wheels, bumper or suspension, could
affect the function of the StabiliTrak
®
system.
We recommend that you contact an
authorised Cadillac workshop before
replacing chassis components.
460_OM_MY09.book Page 151 Wednesday, April 2, 2008 10:32 AM