79Instruments and controls
Follow-me-home lighting
The "Follow-me-home" delay function
allows the headlights to remain on dipped
beam and the reversing lights to remain on
for about 30 seconds after the driver’s door
has been closed.
1 Remove the remote control.
2 Open the driver’s door.
3 Pull the dip switch all the way towards
the steering wheel.
The function is active for 30 seconds after
the door is closed.
Instrument illumination
The brightness of the instrument illumina-
tion can be adjusted by pressing the button.
Headlight levelling 3
Cars with halogen lights
This system enables the angle of the head-
light beam to be adjusted depending on how
the car is loaded.
Turn the light switch anticlockwise to the
desired position. Note: The switch cannot
be turned past position 3.
The system comprises an adjustment motor
for each headlight and a control on the
instrument panel. Adjustments must be
made when the ignition is in position 3.
Special equipment is required for adjusting
the basic headlight alignment.
Adjusting instrument illumination
460_OM_MY09.book Page 79 Wednesday, April 2, 2008 10:32 AM
To Next Page
Loading...
