253Technical data
interrupted automatically when the engine
is started.
Park Heater 3 and Block Heater 3
If the car has an electric or fuel driven
engine heater, the start times are
controlled in Settings under the headings
Block Heater/Park Heater.
Make the settings within 3 minutes after the
engine has been switched off and the
remote control removed from the ignition
switch. During setting the time is extended
in increments of 30 seconds, if 3 minutes
are exceeded. Otherwise the remote control
must be inserted into the ignition switch and
turned to the ON position until the
text "Checking" disappears. Then the
remote control can be turned back,
removed and the process restarted.
1Select Settings using the steering
wheel buttons or .
2 Hold the SET button depressed until a
chime sounds.
3Select Block Heater or Park Heater.
4 Go back/modify using the CLR button.
To now start the heater, MANUAL START
( heater is switched off)
1 Press the SET button.
2Select MANUAL START.
3 End by pressing the SET button.
Go back/modify using the CLR button.
To select the start time, TIMER A, B or C
(heater is switched off)
1 Press the SET button.
2Select TIMER A, B or C using the
steering wheel buttons.
3 Press the SET button. The heater’s start
time can now be adjusted using the
steering wheel buttons. Then press the
SET button, START and the selected
start time is displayed.
4 End by pressing the SET button.
Go back/modify using the CLR button.
To switch off the heater when it is run-
ning
1 Press the SET button.
2Select OFF.
3 End by pressing the SET button.
460_OM_MY09.book Page 253 Wednesday, April 2, 2008 10:32 AM
To Next Page