Massaging Lumbar
If your vehicle has this
feature, the control is
located on the outboard
sides of the front
seats. With the ignition on,
briefly press the top of
the control where it
is marked AUTO to
activate the massaging
lumbar feature.
The massage cycle will run continuously for up to
10 minutes and can be interrupted by briefly pressing the
bottom of the control. The lumbar support can be
adjusted during the massage cycle by moving the control
forward to increase support and rearward to decrease
support. The massage cycle will continue to run even if
the ignition is turned to OFF unless interrupted.
If your vehicle has this feature, it will not have the
adaptive seat feature.
Heated and Cooled Seats
Your vehicle may have heated and cooled front seats.
The buttons are located on
the front seat armrests.
I (Heated Seatback): Press this button to turn on the
heated seatback.
J (Heated Seat and Seatback): Press this button to
turn on the heated seat and seatback.
H (Cooled Seat): Press this button to turn on the
cooled seat.
Press the button to turn on the feature that you want.
A light on the button will display to show which
feature is on.
1-3
To Next Page
Loading...
