DO NOT CUT ANY ORANGE COLORED HIGH VOLTAGE CABLES.
1. Identification / recognition
Lack of engine noise does not mean vehicle is off: vehicle movement capability exists until vehicle is fully shut down. Always wear
appropriate PPE.
First Responder Information Label
2. Immobilization / stabilization / lifting
IMMOBILIZE VEHICLE:
1. Block the wheels.
2. Press the Electric Parking Brake (EPB) switch momentarily.
The red parking brake status light will flash and then stay
on once the EPB is fully applied.
3. Press the button at the end of the shift lever to shift to
P (Park).
LIFTING POINTS:
There are features on the body of the vehicle, for use as
primary lifting points.
Do NOT lift the vehicle from any locations on the high voltage
battery.
3. Disable direct hazards / safety regulations
The vehicle is equipped with a battery management system with internal fault detection. In the event of a “Battery Danger
Detected” notification, DO NOT cut or disable the low voltage system.
MAIN METHOD:
1. Press the POWER button to disable vehicle propulsion.
2. Open the hood. Pull the release handle two times successively.
3. Consider any manipulations of power devices in the vehicle
(steering wheel, power seats, windows, etc.) prior to cutting the
Low Voltage loop.
4. Remove the front compartment sight shield.
5. Double cut the low voltage cables on both sides of the yellow
tape. Ensure that the cuts are clean and that there is no risk of
loose wires touching.
6. Remove the cut section of cable from the vehicle.
This cut will disable the airbags and high voltage.
After disabling low voltage power, wait at least 10 seconds to allow any un-deployed airbag reserve energy to dissipate and
wait at least 1 minute to allow high voltage energy to discharge.
To Next Page
Loading...
