Cadillac XT6 2023 - Page 282

Cadillac XT6 Owner Manual (GMNA-Localizing-U.S./Canada-16405819) -
2023 - CRC - 3/22/22
Driving and Operating 281
the next 5 km/h (5 mph) mark
on the speedometer, press
RES+ to the second detent.
SET− : Move the thumbwheel
down briefly to set the speed
and activate cruise control.
If cruise control is already
active, use to decrease vehicle
speed. To decrease speed by
1 km/h (1 mph), press SET− to
the first detent. To decrease
speed to the next 5 km/h
(5 mph) mark on the
speedometer, press SET− to
the second detent.
* : Press to disengage cruise
control without erasing the
set speed from memory.
Setting Cruise Control
If
J is on when not in use,
SET− or RES+ could get
pressed and go into cruise
when not desired. Keep
J off
when cruise is not being used.
1. Press
J.
2. Get up to the desired
speed.
3. Move the thumbwheel
down toward SET− and
release. The desired set
speed briefly appears in
the instrument cluster.
4. Remove your foot from the
accelerator.
When cruise control has been
set to the desired speed, a
green cruise control indicator
appears on the instrument
cluster and a cruise set speed
message appears on the
Head-Up Display (HUD),
if equipped.
Resuming a Set Speed
If cruise control is set at a
desired speed and then the
brakes are applied or
* is
pressed, cruise control is
disengaged without erasing
the set speed from memory.
Once the vehicle speed
reaches about 40 km/h
(25 mph) or more, move the
thumbwheel up toward RES+
briefly. The vehicle returns to
the previous set speed.
Increasing Speed While Using
Cruise Control
If the cruise control system is
already activated:
.
Move the thumbwheel up
toward RES+ until the
desired speed is reached.
.
To increase vehicle speed in
small increments, briefly
press RES+ to the first
detent. For each press, the
vehicle goes about 1 km/h
(1 mph) faster.
.
To increase vehicle speed in
larger increments, briefly
press RES+ to the second
detent. For each press, the
vehicle speed increases to
the next 5 km/h (5 mph) mark
on the speedometer.
The speedometer reading can
be displayed in either English
or metric units. See
Instrument Cluster 0 127. The
increment value used depends
on the units displayed.