12
Situation Points to check and How to handle Reference
pages
The air purifying effect was not
achieved.
Is the unit placed in a location with bad air circulation such as in an area
completely surrounded by something?
→
Make sure unit is located at least 30 cm away from walls, furniture,
curtains, etc. on both sides, the front, back, and above.
3
Is the air inlet/air outlet dirty?
→
Clean the unit and remove dirt from the air inlet and air outlet on the
unit. If the performance does not improve even after cleaning, replace
the deodorizing/dust collecting/anti-bacterial filter with a new one.
9
~
10
Does dust adhere to the net surface of the filter?
→
Refer to “Replacing the Deodorizing/Dust Collecting/Anti-Bacterial
Filter” to remove dust.
10
The color of the odor and dust
monitor changed, but the air
volume does not change.
Are you using a mode other than automatic mode?
→
In the operation modes other than the automatic mode, the air
volume does not change in accordance with the indications of the
odor and dust monitor.
–
The operation does not stop even
though the air is clean.
The unit will continue to operate with a low air volume even if the room is
clean.
–
The unit smell is
unpleasant.
Is the air inlet/air outlet dirty?
→
Clean the unit and remove dirt from the air inlet and air outlet on the
unit. If the performance does not improve even after cleaning, replace
the deodorizing/dust collecting/anti-bacterial filter with a new one.
9
~
10
Are you using the unit in a room with strong odor?
→
Using the unit in a room with strong odor such as cigarette smoke
or after a barbecue for a long period of time may require more
frequent replacement of the deodorizing/dust collecting/anti-bacterial
filter. When using in such an environment, it is recommended to
regularly air out the room.
–
With indicators on the control
panel flashing, the unit emits
alarm and does not start.
The motor may be damaged, or a foreign object may have entered the
unit.
→
Press the power button to stop the beeps. Unplug the power plug,
then check if there is a foreign object in the filter. If the alarm does not
stop, consult a dealer or your nearest customer service center.
–
To Next Page
Loading...
