• Push the supplied
steel ball pans
onto the ropes and
tighten the grub
screws; here too
we recommend
using a small drop
of screw adhesive.
• In neutral, at least
7mm space must
remain on the ball
socket "W" to the
black sleeve
CHECK:
Push the cable all the way in (Level 1/2)
Then there must be 1-2 mm space left to the sleeve
• When sliding the ball sockets on, pay attention to the alignment so
that the cables do not have to be twisted later:
➢ Opening of the ball socket selector cable "W" points to the lefts
➢ Opening of the ball socket shifting cable "S" points upwards
To Next Page
Loading...