Setting the ECO start and end time
1. Use ↑ or ↓ to select the ECO START or ECO END submenu.
The current ECO time is shown on the display.
2. Press ← to enter the submenu.
The option hour setting flashes and is active.
3. Use ↑ or ↓ to set the correct time (hours).
4. Confirm with ←.
The option minutes setting flashes and is active.
5. Use ↑ or ↓ to set the correct time (minutes).
6. Confirm with ←.
The new ECO time is shown on the display.
Setting the ECO boiler temperature
1. Use ↑ or ↓ to select the ECO TEMPERATURE submenu.
The current ECO boiler temperature is shown on the display. (default = 63°C)
2. Press ← to enter the submenu.
The temperature setting is flashing.
3. Use ↑ or ↓ to select the desired temperature.
4. Confirm with ← .
The new ECO boiler temperature is shown on the display.
Note:
The lower the ECO boiler temperature is set, the longer it takes for the dispenser to become fully functional
again after coming out of ECO mode.
You can set the telephone numbers of operator and service in this menu.
You can also select whether the numbers should be displayed in case:
• cleaning is required (operator)
• a product pack is empty (operator)
• a malfunction is detected (service)
Select the TELEPHONE # menu by using ↑ or ↓ and press ← to access it.
The status is shown in the display:
OPERATOR NR: 0123456789
There are four submenus:
• SHOW OPERATOR NR
• SHOW SERVICE NR
• SET OPERATOR NR
• SET SERVICE NR
Enable/disable telephone numbers
1. Use ↑ or ↓ to select the SHOW OPERATOR NR or SHOW SERVICE NR submenu and press ←.
The display shows: Y (yes) or N (no)
2. Use ↑ or ↓ to select Y to activate the number display or N to deactivate the number display.
3. Confirm with ←.
The new setting will then be shown continuously on the display.
To Next Page
Loading...