LU00
Press 'OK', the display will start flashing.
With touch ⋀ and ⋁ adjust the general attenuation UHF level.
Press the 'OK' button again to confirm.
8. Setting B.I/FM, B.III/DAB
B.I + FM, B.III/DAB entries are equipped with attenuators from 0 level to-30dB.
With touch ⋀ and ⋁ scroll through the filters of your configuration up to
B300
Quickly press the «OK» key.
The display starts to Flash.
Pushing buttons ⋀ and ⋁ can adjust the level of the B.III/DAB filter attenuation.
Press the 'OK' button again to confirm.
Perform the same operation for the adjustment of the B.I/FM after selecting
9 / Power of the entry
Each input can provide a supply voltage of 12 to 24 VDC.
Procedure:
Programming for TV food menu is accessible only from the "POWER ON" on
the display of the amplifier status. (screen off, bottom right led). To access the
State 'POWER ON' simultaneously press keys ⋀ and ⋁ on any screen provided
that it does not blink.
If the amplifier is not yet in the ' POWER ON ' State can force it by
simultaneously pressing the keys ⋀ and ⋁.
Starting from this State, press for 3 seconds on the keys ⋀.
The display shows the menu of remote supply 12 or 24 Volt.
To continue the procedure and choose the remote supply voltage, press the
«OK» key.
The display will begin to Flash: it is in the mode "programming settings".
Press the buttons ⋀ and ⋁ to select the 12 or 24 Volt voltage.
Push on the 'OK' button again to confirm your choice.
To enable the remote supply or check the presence of voltage at the inputs
9
To Next Page
Loading...