California 15020C-22060

Questions and Answers

G
gonzalezgeorgeAug 13, 2025
What to do if my California 15020C-22060 motor does not start or starts slowly?
- C
  Christopher ThorntonAug 13, 2025
  If the motor on your California Air Compressor does not start or starts slowly, it could be due to low voltage supply. Check that the main voltage corresponds to the air compressor specifications. Also, an extension cord that is too thin or too long can cause a voltage drop. Use heavy-duty extension cords and ensure the compressor is plugged into a fully functional power outlet.
J
james22Aug 16, 2025
What to do if my California 15020C-22060 doesn't seem to provide as much air as it used to?
- D
  deborahbrownAug 16, 2025
  If your California Air Compressor isn't providing as much air as it used to, or cuts off quickly, it may be due to a tank full of water from condensation. Open the drain valve and release the water from the tank to resolve this.
C
Courtney DavisAug 20, 2025
Why has my California 15020C-22060 stopped and does not start?
- J
  Jessica NobleAug 20, 2025
  If your California Air Compressor has stopped and won't restart, the thermal protector may have activated due to motor overheating. Ensure the main voltage matches the compressor's specifications. Avoid thin or long extension cords, as they can cause voltage drops and overheating. Also, excessive continuous use (over 1 hour) can cause overheating. Allow the motor to cool down.
J
Jenny JohnsonAug 25, 2025
How to fix a pressure drop in my California 15020C-22060 Air Compressor tank?
- P
  paulberryAug 25, 2025
  To fix a pressure drop in your California Air Compressor tank, first let the compressor build pressure, ideally to the maximum. Then, apply soapy water to all air connections and watch for bubbles, which indicate leaks. Tighten any leaky connections. If the issue continues, seek further assistance from the seller.
M
mcdonaldhannahAug 28, 2025
What to do if the motor pump unit of my California Air Compressor does not stop at maximum pressure?
- S
  Sandra PerezAug 28, 2025
  If the motor pump unit on your California Air Compressor does not stop when the tank reaches its maximum working pressure (75 PSI), stop the compressor immediately and contact Customer Support for assistance, as the pressure switch may be defective or need adjustment.
P
Pamela ChavezSep 1, 2025
What to do if the unloader valve leaks when the California Air Compressor is idle?
- S
  Sean CaldwellSep 1, 2025
  If the unloader valve leaks when your California Air Compressor is idle, it's likely due to a defective unloader valve seal. Release all pressure from the air tank. Then, remove the unloader valve plug and clean the valve seal. Replace the seal if necessary, and then reinstall all components.
D
davidmarkSep 4, 2025
Why is my California Air Compressor so noisy with metallic clangs?
- C
  Caitlin MooreSep 5, 2025
  If your California Air Compressor is making metallic clanging noises, the compressor head gasket or reed valve is likely damaged. Stop the compressor and contact the dealer for assistance.
W
William PerrySep 8, 2025
Why doesn't my California 15020C-22060 reach the maximum pressure?
- B
  Brett AcostaSep 8, 2025
  If your California Air Compressor isn't reaching maximum pressure, the compressor head gasket or reed valve may be faulty. Stop the compressor and contact the dealer.