EasyManua.ls Logo

Calira MES Module B - Page 29

Default Icon
68 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...

 
    


Lerchenfeldstr. 9
87600 Kaufbeuren
Tel.: 049 (0)8341 9764-0 Fax: 049 (0)8341 67806
29
Charging process: Automatic
Automatic
switching mains:
Main charging
process:
Post charging phase:
Holding charge:
OFF when battery voltage reached
14.4 V
Ten hours constant 14.4 V in the
case of gel batteries.
Four hours constant 14.4 V in the
case of liquid batteries.
Holding charge, constant at 13.8 V
Temperature
dependent control:
(optional)
Mains
Solar
Booster
The values of the automatic switching refer to a battery
temperature of 20° C. When using a temperature sensor at
the battery II, these values vary as a function of the
battery temperature.
High temperature > Lowering of the threshold values.
Low temperature > higher threshold values.
Charging current
solar:
max. 12 A, 2 solar panels each of 85 W
Voltage solar:
14.4 V / 13.8 V
Charging current
booster:
10 A
Voltage booster: 14.2 V
Low-voltage
monitoring:
OFF at 10.8 V
ON at 12.5 V
Application: Parallel operation, buffer operation, general charging
operation
Temperature: Ambient temperature of –25 °C to +35 °C. During
operation, the housing may heat up to approx. 75 °C.
Cooling: By convection
Implementation: According to Association of German Electrotechnical
Engineers regulations and the provisions of the Instrument
Safety Act.
Test labelling:

Table of Contents

Related product manuals