Calira MES Module B - Electrical Connection Guide



   
      


Lerchenfeldstr. 9



87600 Kaufbeuren



Tel.: 049 (0)8341 9764-0 Fax: 049 (0)8341 67806
34
Connection

0, / 
 &/

Remove the terminal area covers from Module A and Module B.
Always check whether the connector of the vehicle battery (battery I) on
Module A has been separated by pulling out the feed plug! The feed plug
connects the Module A with the contacts 9 and 13 to the 13-pole coupling plug.
(See also MES Module A operating instructions, page 13, picture 8, pos. 1).
+ -
+ + - -
Solar
NC + -
Starterbatterie
15A Temp. RS485 Schalter
11
1
10
9
#$%&'$) 