7
© 2021 Calix. All rights reserved.
Simplify. Excite. Grow.
1
Connect the GigaSpire
BLAST u4 to a power outlet.
2
3s
When the LED is red on the satellite u4, you can begin
pairing it with the first Gigaspire BLAST u6.
Press and hold the W PS button on the first u6 system
for 3 seconds, then on the second u4 system for 3
seconds (less than 30 seconds apart).
Be sure to set up your Calix
CommandIQ App (see last page for
details).
3
Note: The LED on both of the systems
will flash GREEN when pairing for
wireless backhaul.
The u6 should blink green and return to
solid blue within 2 minutes. The u4 will
cycle through colors as it connects and
updates.
Once pairing is successfully complete,
both systems will show a solid blue
light (this may take several minutes).
You can then move to step 3.
Otherwise, re-attempt until pairing is
successful.
3s
Setting up your second GigaSpire BLAST u4 or u4m
(as a satellite) Using wireless backhaul
To Next Page
Loading...
