Calix GM1020 gigaMESH - Mounting the gigaMESH

To Next Page

To Previous Page

- 3 -

Mounting the gigaMESH

The GM1020 gigaMESH must be plugged into an AC power

outlet. Orientation can be either up or down relative to the

power outlet.

Powering the 804Mesh

To power the equipment:

1. Unbox the gigaMESH and remove the outer plastic

bag.

2. Set the SSID/barcode label aside temporarily.

3. Plug the gigaMESH into an available wall socket.

Note: The gigaMESH can be oriented in an up or

down position (relative to the power plug)

however for maximum Wi-Fi coverage, Calix

recommends installing in an “up” position.

4.85”

12.3 cm

2.76”

7 cm

1.89”

4.8 cm

WAN / LAN