Calix GM1020 gigaMESH - Managing the gigaMESH; Connecting the gigaMESH to your Network; Received Signal Strength Indicator

- 4 -
Managing the gigaMESH
The initial set-up and ongoing maintenance including soft-
ware upgrades of the gigaMESH is managed remotely by
your service provider.
Connecting the gigaMESH to your Network
To complete the network connection, ensure the gigaMESH
has completed boot-up and connect in either of two options:
1. Connect the GM1020 gigaMESH to the upstream
gigaSPIRE using a CAT5 or better Ethernet cable.
The gigaMESH will automatically synchronize with the
upstream gigaSPIRE.
2. For wireless connections, press the WPS button on
both the gigaMESH and gigaSPIRE and hold for three
seconds. Once pairing is completed, LED will illuminate
blue.
About the Received Signal Strength Indicator of t
The LED array on the front of the gigaMESH is a dual-seg-
ment indicator. This array off ers two primary functions:
1. Displays diff erent colors based on its relative location
to the upstream gigaSPIRE with respect to its signal
strength.
2. Displays current connectivity status of the GM1020
gigaMESH.