Calix GM1020 gigaMESH - Frequently Asked Questions

- 5 -
LED State gigaMESH State
In pairing mode, the gigaMESH is too close to the
host (gigaSPIRE).
In pairing mode, the gigaMESH is too far away from
the host (gigaSPIRE).
The gigaMESH is ideally located.
Note that LED states above refl ect a GM1020 in an “up” position
(WPS button on the bottom of the unit).
Frequently Asked Questions
Q: How do I reset the device without having to unplug
the unit?
A: If the RESET button is depressed for less than 10
seconds, it resets the unit using the current confi guration
settings.
Q: How do I reset the device back to factory settings?
A: Pressing the RESET button on the back of the unit for at
least 10 seconds.
Q: What if the User Name or password are forgotten for
the gigaSPIRE?
A: Press the reset button of the gigaSPIRE for at least ten
seconds.
Q: What mounting options are available for installing
the GM1020 gigaMESH?