40
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
The following table describes the parameters.
Parameter Description
Parameter Description
Enable IP Filter Enables or disables IP filter function.
Mode Includes two mode: Drop or Accept. Drop means blocking
the IP flows that meet the rule. Accept means allowing the
IP flows that meet the rule.
Source Start IP Address Setup the source IP start address.
Source End IP Address Setup the source IP end address.
Destination Start IP
Address
Setup the destination IP start address.
Destination End IP
Address
Setup the destination IP end address.
Protocol Select the protocols, including the following options:
ALL: all protocols
TCP
UDP
TCP/UDP
ICMP
Add Button Click this button, to add a new filtering rule for above
configurations.
After the configurations are done, click Save button to save it.
To Next Page
Loading...