Calix T076G - Page 23

23
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
The following table describes the parameters.
Parameter Description
Parameter Description
WAN
Connection List
By default there is a TR-069 connection. Another option is to create
a new WAN connection.
Delete Select this check box to delete this WAN connection.
Enable/Disable Enables or disables this WAN connection.
NAT Enables or disables the NAT function.
Service Includes four service types: VOIP, TR-069, Internet, and IPTV.
Enable VLAN Select this check box to enable VLAN feature on WAN port. When
selected, the below VLAN ID setup, and 802.1p priority setup will
be configurable. Otherwise they can not be configured.
VLAN ID Setup VLAN ID of WAN.
VLAN PRI IEEE 802.1p Priority of WAN.
WAN IP
Version
Includes three options: IPV4, IPV6, and IPV4+IPV6. If IPV4 is
selected, it will be requested to enable/disable OPTION 60 Enable
and input Vendor Class ID. If IPV6 is selected, it will be requested
to select IPV6 Address/Prefix.
WAN IP Mode Used to select the method to get the WAN IP address. There are
three options: PPPoE, DHCP, and Static IP. If PPPoE is selected, it
will be requested to input username/password, and keep alive time.
If Static IP is selected, it will be requested to input the IP address,
netmask, gateway, Primary DNS and Second DNS address.
After the configurations are done, click Save button to save it.