4
POWER CORD INSTRUCTIONS
A short power-supply cord or detachable power-supply cord is provided to reduce risks resulting from
becoming entangled in or tripping over a longer cord. Longer detachable power-supply cords or extension
cords are available and may be used if care is exercised in their use. If a long detachable power-supply
cord or extension cord is used on short-cord models:
a. The marked electrical rating of the detachable power-supply cord or extension cord should be at least
as great as the electrical rating of the appliance;
b. When the product is of the grounded type, the extension cord shall be a grounding type 3-wire cord;
and
c. The longer cord should be arranged so that it will not drape over the counter top or table top where it
can be pulled on by children or tripped over unintentionally.
Do not pull, twist or otherwise abuse the power cord.
Do not wrap the power cord around the main body of the blender during or after use.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
POLARIZED PLUG
This appliance has a polarized plug, (one blade is wider than the
other). As a safety feature to reduce the risk of electrical shock, this
plug is intended to fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to defeat this safety feature or modify the plug
in any way. If the plug fits loosely into the AC outlet or if the AC outlet feels warm do not use
that outlet.
19. If your blender comes with a grounded plug, connect to properly grounded outlets only.
For containers with no lids or vents (when inserted in the blender), such as personal Blend and
Go containers:
20. Do not blend carbonated, hot or boiling liquids and ingredients, as this may create pressure buildup.
Only blend non-carbonated liquids and ingredients that are at room temperature or cooler. If the
container is warm to the touch, allow to cool before opening.
21. Do not use the blender for longer than 1 minute at a time to avoid heat and pressure buildup. Allow to
cool for 1 minute between cycles.
To Next Page
Loading...
Need help?
General
