Need help?Do you have a question about the Cambium PTP 450 and is the answer not in the manual?
Details the steps for upgrading the system software.
Explains two methods for resetting the unit to factory default settings.
Key safety guidelines to prevent injury or loss of life.
Requirements for proper grounding to protect against lightning.
Guidelines on RF field presence and maintaining safe separation distances.
General compliance information and specific requirements for radar systems.
Procedure for investigating and reporting issues encountered with the equipment.
Guidance on obtaining repair and service details for unit failures.
Recommendations for configuring and implementing security practices for the system.
Introduces key features, uses, variants, and components of the PTP 450.
Describes the BHM and BHS radios used in the PTP 450 system.
Details cabling and lightning protection components for PTP 450 installation.
Explains how the PTP 450 wireless link operates, including modulation and security.
Introduces the PTP 450 management system, interface, and software.
Details the checks and precautions to perform before configuring the unit.
Outlines Cambium's standard hardware warranty, covering defects and repair/replacement terms.
General| Model | PTP 450 |
|---|---|
| Max Throughput | 200 Mbps |
| Latency | < 5 ms |
| Ethernet Ports | 2 x 10/100/1000 Mbps |
| Security | AES-128, AES-256 |
| Mounting | Pole or Wall Mount |
| Category | Point-to-Point Wireless |
| Channel Width | 5, 10, 20, 30, 40 MHz |
| Modulation | 16QAM, 64QAM |
| Operating Temperature | -40 to +60 °C |
To Next Page
