14
3. Press ‘Play’. The CD player will now play the entire disc in random order. It is also possible to press the Random button during playback to listen to
tracks in random order.
4. Press the Random button to exit. The disc will continue playing to the end in the correct order.
5. Press the ‘Stop’ button at any time to stop the disc.
Note: Selecting ‘Random’ mode when ‘RPT ONE’ has been selected will automatically cancel ‘RPT ONE’ mode.
USING THE REMAIN FUNCTION
1. Ensure that the disc is playing.
2. Press the Remain button on the remote control once to display the time remaining for the track playing.
3. Pressing the Remain button the second time will show the total remaining disc time.
4. Press the Remain button again either before or during playback to return to normal play mode.
PROGRAMMING DISC PLAY
It is possible to program the AXC35/AXC25 to play back in any order only the tracks you wish to listen to.
1. Ensure that a disc is loaded. The display should show the TOC data.
2. Press the ‘Prog’ button on the remote control. The Program set-up will appear on the display.
3. Use the reverse ‘Skip/Scan’ and forward ‘Skip/Scan’ buttons or enter the track number that you want to program as your first track.
4. Press the ‘Prog’ button on the remote. The desired track is now programmed. The program number automatically increases by one for the next entry.
5. Repeat steps three and four until all your desired tracks are entered. A maximum of 20 tracks can be programmed.
6. Press the ‘Play’ button to begin programmed playback.
7. Press the ‘Prog Clear’ button on the remote to clear all programmed tracks.
To Next Page
Loading...
Need help?
General
