6
Front panel controls
Last updated: 7月 29, 2022 10:27. Revision #5437
1. Power button - Switches the unit between Standby mode (indicated by dim power LED) and On (indicated by bright power LED). Standby mode is a low
power mode where the power consumption is less than 0.5 Watts. This product has APD (Auto Power Down) enabled as default. After inactivity of 20
minutes, the product will automatically switch to Standby.
Auto Power Down (APD) You can enable and disable the unit’s APD setting. This can be adjusted by pressing and holding the Power button until the LED
flashes in sequence.
The two options below show which option is selected.
Standby flashes 5 times - APD disabled
Standby flashes 10 times - APD enabled
Note: Make sure the unit is On, before making changes to the APD function.
2. Infrared sensor -
Receives IR commands from the supplied remote control. An unobstructed line of sight between the remote control and the sensor is required.
3. Display -
Alpha-numeric characters which display playback information. On inserting a disc, the CD player will take a few seconds to read the Table of Contents
(TOC) information from the disc. The display will then show the number of tracks on the CD and the total length of the CD.
4. Open/Close -
Allows you to open and close the disc tray. After placing a CD in the tray, press Open/ Close to close the tray.
To Next Page
Loading...
Need help?
General
