Pag. 16 - FA01024M4A v. 1 11/2017 © Came S.p.A.
will switch o and then switch on again).
3. The module restarts in DHCP mode in default factory mode.
If the module which is being reset to factory default mode is
already registered and configured on a CAMEConnect account,
the module and all devices connected to it must be removed
from the account.
Configuring the module over the web
If you already know the module's IP, or if the module is in the
preset, 192.168.6.6, static, IP mode, you can configure it on a
browser and PC, provided it is connected and configured on the
same network or that is connected directly to the module, that is,
with the preset, static IP.
4. Start your browser and enter the module's IP address.
5. Enter your username and password in the login page 🅲. The
factory credentials are:
Username = adminPassword = admin
Once you've entered the access credentials, you can then access
the following pages.
The Network page 🅳
This page features information on how to access the module's
network, such as:
• MAC address,
• Static/DHCP, IP assignation mode
• IP, network mas, network gateway.
The various settings, except the MAC address, can be changed to
install the module on your own network.
Any changes will only take eect once the device is re-
started; if the network parameters are wrongly configured,
it may be necessary to restore the default, factory settings.
The Info page 🅴
This page features information on the state of the module's con-
nection to the Cloud, plus information on any associated RSLV001
modules, that is, serial numbers, radio signal strength, and firm-
ware version.
N.B.: The information on the quality of the signal and the firm-
ware version are available only if the module is connected to
CAMEConnect.
The User page 🅵
This page is for changing the user password of the user who ac-
cessed the network.
N.B.: The password must have between four and 16 characters.
The System page 🅶
This page is divided into three sections.
[System info]
It features the device's keycode and the firmware version
To Next Page
Loading...
Need help?
General
