6. AUTOMATION AND SLIDING DOORS INSTALLATION
6.1 Wall mounting support profile [FLUO-SL], or drive unit
profile [FLUO-SLB].
Chapter 4.5 shows the vertical mounting dimensions of
FLUO-SL automations.
The automations FLUO-SL are compatible with the majority
of frame systems in trade.
Fixing of the support profile [FLUO-SL], or the drive unit
profile [FLUO-SLB], to the wall must be safe and suitable for
the weight of the doors. Distribute the fixing points every
500 to 800 mm (or 300÷500 mm for SL5H, SL5B) along the
present lines on the aluminium profile, using suitable plugs
and screws, not supplied by us .
Note: the wall must be straight and smooth, otherwise you
have to prepare adequate thickness or iron plates on which
to secure the support profile [FLUO-SL], or the drive unit
profile [FLUO-SLB], to allow for proper levelling.
6.2 Attach the automation to the support profile [FLUO-SL].
Note: if the automation has not been assembled, making
the assembly of the components as described in Chapter 5.
6.3 Must be prepared and executed the channel and the
holes for the passage of the power cord and cables for
connecting the control and safety devices (sensors, function
selector, buttons, etc.).
6.4 Adjust the tension of the belt with the transmission unit
as shown in the figure:
- Manually push to left the transmission unit, so as to
tension the belt, and attach it to the drive unit profile by
screws,
- Loosen the screw [a],
- Tighten the screw [b] and compress the spring until 2 mm
(always check manually, the belt tension is not too tight or
too loose ),
- Lock the adjustment of the belt tension by tightening the
screw [a].
To Next Page
Loading...
