CAME GGT80AGS - BALANCE SPRING SELECTION; Choosing Balance Spring Hole

Page 14 - Manual FA01384-EN - 03/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
Choosing the hole for fixing the balance spring
Passage width clearance (m) 4,00 < 4,50 4,50 < 5,00 5,00 < 5,50 5,50 < 6,00 6,00 < 6,50 6,50 < 7,00 7,00 < 7,80
Boom with LED strip
A A B A A A A A A B B
Boom with LED strip and single skirt*
B A A A A B B B B B B
-
Boom with LED strip and full-height skirt
A A A A B B B B
---
Boom with LED strip and swing rest
A B A A A A A A A A
-
Boom with LED strip, single skirt and swing rest
A A A A A A
----
Boom with LED strip, full-height skirt and swing rest
A A B B B B
----
Simple boom means the boom complete with slot cover, cap and rubber profile.
If the passage is wider than 4 m, you must use a support for the boom (fixed or mobile).
Single skirt (803XA-0340):
- max 2 modules for a 4 metre boom
- max 3 modules for a 6 metre boom
- max 4 modules for up to a 7 metre boom
Full-height skirt (803XA-0350):
- max 2 modules for a 4 metre boom.
- max 3 modules for a 6 metre boom.