Need help?Do you have a question about the CAME Wing 40 and is the answer not in the manual?
General| Brand | CAME |
|---|---|
| Model | Wing 40 |
| Category | Turnstiles |
| Language | English |
Essential checks before installation to ensure safety.
Guidelines for safe installation practices.
Advice for end-users on safe operation and maintenance.
Explains symbols and provides a general overview of the turnstile.
Defines the product's intended applications and operational constraints.
Lists the technical data and specifications of the turnstile.
Lists and illustrates the main physical components of the turnstile.
Provides detailed dimensions for different turnstile configurations.
Details system requirements and preliminary checks for installation.
Lists necessary tools and minimum cable thicknesses for installation.
Illustrates a typical standard installation of the turnstile.
Shows various application scenarios for the turnstile.
Describes initial disassembly steps for installation.
Guides on separating the base and slide ring from the column.
Instructions for positioning and marking anchor holes for the base.
Details on setting up corrugated tubes for cable routing.
Steps to position the base and secure the column to the floor.
Guidance on connecting the power supply to the central column.
How to check and adjust endstop positions for the wing barrier.
How to set different opening arc angles (90°, 75°, 60°).
Adjusting limit switches for precise buffer and leaf alignment.
Fine-tuning the endstop point for accurate operation.
Steps for removing and reinserting the wing barrier leaf.
Distributing cables and securing the leaf to the transmission shaft.
Installing the centering pin and drag plate onto the tube ring.
Positioning the control board support and inserting the deflector.
Securing the cover with the lock and inserting the final cap.
Lists and describes the main components on the electronic board.
Explains the meaning of different LED signal light indications.
Details power supply connections and transformer wiring.
Explains connections for warning devices like photocells.
Outlines connections for various control devices.
Describes the gearmotor with encoder and its connections.
Explains connections for stop buttons and opening devices.
Details inputs for safety devices like photocells.
How to fit the R700 board and memory roll for user data.
Explains the ESC, <>, and ENTER buttons for programming.
Provides a map of the available programming functions and menus.
Guides on performing motor tests and calibrating travel.
How to perform travel calibration and reset parameters.
Configuration of safety input functions like F1, F2, F3.
Setting the automatic closing timer duration.
Adjusting the pre-flashing time for the LED indicator.
Setting opening, closing, and slow-down speeds as percentages.
Setting the speed for the calibration phase.
Adjusting obstacle detection sensitivity during travel and slow-down.
Setting slow-down points and approach areas for movement.
Enabling combined or RBM84/CRP modes for multiple turnstiles.
Functions for saving and reading data from the memory roll.
Transferring parameters and setting up the antipassback function.
Configuring entry direction and alarm activation time.
Setting peripheral numbers and adjusting closed wing barrier position.
Procedures for registering and cancelling users.
Viewing the current software version.
Step-by-step guide for conducting motor movement tests.
Balancing the closing angle using the limit-switch offset.
Performing automatic calibration of the wing-barrier travel.
Important warning regarding the wing-barrier's closing position.
Procedure for registering new users via transponder card.
Steps for cancelling individual user registrations.
A numbered list of user slots from 1 to 150.
Details on connecting multiple turnstiles in a combined system.
Setting up the MASTER turnstile for combined operation.
How to transfer settings from the MASTER to the SLAVE turnstile.
Calibrating travel for the SLAVE turnstile after parameter transfer.
Log for regular maintenance tasks performed by end-users.
Log for specialized repair and improvement jobs.
List and explanation of error messages and notifications.
Guidelines for environmentally sound disposal of the product.
Statement of compliance with relevant directives (CE).
To Next Page
