CAME Wing 40 - Feature Configuration Parameters; Travel Calibration and Parameter Reset; Input Function Settings; Automatic Closing Time Setting

F
i
A4
0
ENTER
>
>
ENTER
>...>
i
F
i
0
i
ENTER
ENTER >
>
F
i
0
i
ENTER
>
>
ENTER
>...>
F
3
F
i
ENTER
>
>
ENTER
> >
>...>
F9 i
i
F
i
0
i
ENTER
>
>
ENTER
06
F
2
>
F
i
A3
0
i
ENTER
>
>
ENTER
>...>
2
ENGLISH
p.
19
19 - Manual code:
119G3565EN
119G 3 565 E N ver.
2.0
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning
Features menu
A 4 (Reset parameters):
data restoring procedure (for default settings) and travel calibration cancellation.
0 = Deactivated; 1 = Activated.
F 1 (Total Stop 1-2) - N.C. input: wing-barrier stop with possible exclusion of the automatic-closing cycle; to restore
movement act on the command device. Insert safety device on [1-C2]; if unused, set the feature to 0.
0 =Deactivated (default) 1 = Activated
F 2 (2-CX input): N.C. safety contact input (reopen while closing).
0 = deactivated (default); 1 = Activated.
F 3 (2-CY input): N.C. safety contact input (reopen while closing).
0 = deactivated (default); 1 = Activated.
F 19 (Automatic closing time): the automatic closing timer activates at the closing endpoint. The pre-set time is
adjustable, and is anyhow conditioned by a possible intervention by the safety devices and is deactivated after a total
emergency stop or when the power is cut.
The waiting time can be deactivated or adjusted from 1" to 60".
1 = 1 second (default); 2 = 2 seconds; .................. 60 = 60 seconds.
A 3 (travel calibration): automatic gate-wing travel calibrating operation (see the paragraph about calibrating travel).
0 = Deactivated; 1 = Activated.
Warning! If needed, you can restore the factory settings with the following feature: