CAME Wing 40 - Detailed Installation Steps; Preliminary Operations for Installation; Base and Column Separation

ENGLISH
p.
7
7 - Manual code:
119G3565EN
119G 3 565 E N ver.
2.0
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning
Remove the
deflector and the
card support from
the tube.
Separate the base and
slide ring from the co-
lumn by removing the
screw and washer.
Remove the screws from
the drag plate.
Remove the cover
with the key.
Remove the plate, the centering pin and lock
extender and separate them.
Slip the tube
out of the cen-
tral column.
Preliminary operations
Installation
⚠
The following illustrations are just examples, in that the space for securing the operator and accessories depends on
the installation zone. It is the installer's responsibility to choose the most suited solution.
⚠
Warning! Use hoisting equipment to transport and position the turnstile.
During the pre-mounting and fastening phases, the turnstile could be unstable and there is a risk it could tip over. So
be careful to not lean against the turnstile until it is completely mounted.