CAME Wing 40 - Setting Up and Anchoring the Base; Base Placement and Marking; Cable Routing Setup

40 mm min.
90°
90°
90
ENGLISH
p.
8
8 - Manual code:
119G3565EN
119G 3 565 E N ver.
2.0
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning.
Setting up and anchoring the base to the ground
Check that there are no dips
on the ground where you
will anchor the turnstile.
Position the anchoring base
as shown in the drawing
(the gate wing is perpen-
dicular to the wall). Use a
pencil to mark anchoring
holes.
Note: when installing near
wall, respect the 400 mm
minimum distance.
Perforate where marked.
Set up corrugated tubes for cable to go through. Lay the cables through the tubing.
Wing-
barrier
Wall
Possible cable passage if installing
on fi nished fl oors.
Endstop position
Endstop position