CAME Wing 40 - Data Management and Safety Features; Saving and Reading Data from Memory Roll; Parameter Passing and Antipassback; Entry Direction and Alarm Settings

F
i
ENTER
> >
ENTER
>
>
>...>
55F
06
F
i
0
i
ENTER
>
>
>
ENTER
>...>
45F
2
0
i
F
i
0
F i5
i
ENTER > > ENTER
>...>
F
i
0
25F
i
ENTER > > ENTER
>...>
F
i
0
i
ENTER > > ENTER
>...>
35F
F
i
0
F05
i
ENTER > > ENTER
>...>
ENGLISH
p.
22
22 - Manual code:
119G3565EN
119G 3 565 E N ver.
2.0
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning.
F 53 (Antipassback): prevents access to an area when the person is already inside. Can be used to avoid using one
card for two or more consecutive accesses in the same area; for example a gym, to prevent clients from entering with
the personal card of someone who has already entered.
0 = Deactivated; 1 = Activated;
F 54 (Entry direction): setting the entry direction.
0 = Counter-clockwise (default); 1 = Clockwise; 2 = Both directions;
Note: if the feature is set to 2 both directions, the (2-4) contact operates the opens wing-barrier in the direction
opposite that of contact (2-3).
F 55 (Alarm): setting the alarm activation time. It activates when contacts 2-CX and 2-CY are opened with wing-
barrier/s closed or during the pre-flashing phase set on F 21.
The time can be adjusted from between 1” to 60”.
0 = Deactivated (default); 1 = 1 second; .................. 60 = 60 seconds.
F 51 (Data reading): for loading memory roll data onto the electronic control board.
Note: this function appears on if after you fitting the memory roll onto the electronic board.
0 = Deactivated; 1 = Activated.
F 52 (Passing parameters): function for load the parameters from Master to Slave. The parameters are:
- opening and closing speeds;
- opening and closing slow-down speeds;
- opening and closing slow-down points;
- slow-down and travel sensitivity;
- calibration speed.
Note: this function appears on if function F49 is set to combined connection.
0= Deactivated; 1 = Activated.
F 50 (Save data): saves users and all settings in the memory roll.
Note: this functions works only is the memory roll is fitted to the electronic control board.
0 = Deactivated; 1 = Activated