18
ENGLISH
p.
14 - Manual code:
119G 3 565 E N ver.
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning.
Description
Main component parts
Command and control electronics
The electronic board is powered by 24 V AC.
the command devices and accessories are powered by 24 V. The accessories must not exceed 10 W overall.
All connections are protected by quick fuses.
The functions on the entry and exit contacts, the time settings and user management, are all set and viewable on the
display which is managed by dedicated software.
⚠
Warning! Before acting on the control panel, cut off the power supply.
1. Programming buttons
2. Programming indicator LED
3. Memory roll card connector
4. R700 board connector for the first command device
5. R700 board connector for the second command device
6. Display
7. Terminals for control devices or coupled connections
8. Warning device terminals
9. LED luminous band connector
10. Transponder terminals
11. Command devices terminals
12. Accessories power supply terminals
13. Board power supply terminals
14. Accessories fuse
LED signal light
Green LED Flashing Opening Turnstile leaf/ves
Red LED
Stays on
permanently
Stand-by
Slow fl ashing Closing wing barrier/s
Quick fl ashing
Pre-fl ashing time before the wing-barrier/s closing phase
Emergency stop button (N.C. contact)
Blue LED
light
Flashing Automatic closing time
15. Card fuse
16. Motor/encoder connector
17 Voltage present LED warning light
18. Line fuse
FUSE TABLE
Line fuse
1.6 1.6 A-F (230 V)
3.15 3.15 A-F (120 V)
Accessories fuse 1 A-F
Control unit fuse 1 A-F
To Next Page
Loading...
