² ²
FIG. B
ENGLISH
p.
13 - Manual code:
119G 3 565 E N ver.
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning
Fitting the upper cap
Insert and fasten the drag plate
onto the tube ring.
Tighten the lock exten-
der above the plate,
position and fasten
the hooking bracket
above the extender, see
figure B.
Position the electronic control board's support above the support bracket,
only after passing the electric cables through the hole in the support.
Insert the centering pin.
Hook up the electronic control bo-
ard's support by slightly turning it
clockwise.
Insert the cover and fasten it with the lock by tur-
ning the key counter clockwise.
Finally, insert the cap.Insert the deflector as shown
in the drawing.
To Next Page
Loading...
