CAME Wing 40 - Motors Test and Limit-Switch Offset; Performing Motor Movement Tests; Adjusting Closing Endstop Offset

ESC < > ENTER
ESC < > ENTER
> E
E
>
>
---
ESC < > ENTER
ESC < > ENTER
2
a
I
oP I
cl I
ESC < > ENTER
ESC < > ENTER
5
i
ESC < > ENTER
75F
5
-
i
75F
ESC < > ENTER
X
A
M
²

²
X
A
M²

²
ENGLISH
p.
24
24 - Manual code:
119G3565EN
119G 3 565 E N ver.
2.0
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning.
Select A 2. Press ENTER to confirm.
Select 1 to activate the test. Press ENTER to
confirm.
Will appear, meaning it is standing by for a
command.
Keep pressed the button indicated by the >
arrow and check that the wing barrier completes
a clockwise movement.
Do the same procedure using the button indica-
ted by the > arrow to check that the wing barrier
completes an anti-clockwise movement.
Motors test
Closing limit-switch o set
Select F 57 Press
ENTER to confirm.
Press the arrow button
> to compensate the
end-stop closes counter
clockwise.
Press ENTER to confirm.
After positioning the mechanical stops and calibrating the travel, the O set closing endstop operation is for
balancing the closing angle on curved entrance systems.
Or the arrow button < to
compensate the endstop
closes clockwise.