CAME Wing 40 - Adjusting the Limit Switch; Checking Endstop Positions; Setting Opening Arc Angles

^²
^²
²
²
^²
^²
90˚
²


ENGLISH
p.
10
10 - Manual code:
119G3565EN
119G 3 565 E N ver.
2.0
2.0 09/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without prior warning.
Adjusting the limit switch
Fit the wing-barrier to the drive shaft to
check the position of the endstops.
If you wish to adjust the wing-bar-
rier opening, change the position
of the mechanical endstops, see
illustrations shown below.
The default position of the endstops is at 90°. You can also have openings which
are less than 90° arcs (up to 60°)
by doing the following:
A = Leaf opening at 90° (default
position).
B = Leaf opening at 75°.
C = Lead opening at 60°.
ABC
Example 60° opening arc. Loosen the buffer and completely
loosen the screw.
Buffer