Page 16 - Manual FA01384-EN - 03/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
Balancing the boom
1
Release the gearmotor.
2
Manually turn the spring to increase or reduce the traction. The boom
should stabilise at 45°.
Where there are two springs, carry out the procedure on both springs at
the same time.
3
Fasten the locknut.
Position the boom vertically.
4
Lock the gearmotor
Check the proper working state of the spring. When the boom is vertical,
the spring is not taut. When the boom is horizontal, the spring is taut.
4
To Next Page
Loading...
