FA00947M4A - 11/2017
- Keep pressed the T2 button on for about 10 seconds on
the RIOED8WS card, until the CH1 and CH2 LEDs fl ash red.
☞ If you replace any device on the system, you will have
to RESET and then again save all of the system devices.
Batteries
⚠ Only replace with the same or equivalent battery type.
⚠ Keep the batteries away from children’s reach. If swal-
lowed, seek immediate medical attention.
⚠ The supplied battery’s life also depends on its storage
time. Fit the batteries when saving.
⚠ When the batteries are almost fl at on the RIOED8WS
device, it makes a buzzing sound every 10 seconds.
Troubleshooting
See the chapter on: troubleshooting issues on the RIOCT-
8WS or the RIOCN8WS control card.
Maintenance
Clean the wireless module with a moist cloth; do not use
any solvents.
CAME S.p.A. declares that the RIOED8WS photocells
conform to the provisions of directive 2014/53/EU.
The complete wording of the EU declaration of con-
formity is available at the following Internet address:
www. came.com.
RIOED8WS paired with RIOCT8WS and together with an
operator, or a control panel, with safety test enabled, is a
Category 2 safety device according to EN 954-1.
RIOED8WS paired with a RIOCN8WS, is a Category 2
safety device according to EN 954-1.
Decommissioning and disposal. Dispose of the pack-
aging and the device at the end of its life cycle respon-
sibly, in compliance with the laws in force in the country
where the product is used. The recyclable components
are marked with a symbol and the material's ID marker.
The data presented in this manual may be changed, at
any time, and without notice.
Measurements, unless otherwise stated, are in millim-
eters.
To Next Page
Loading...
