FA01259M4A - 10/2018
⚠ Fit the RIOED8WS photocells near the RIOCN8WS or
the RIOCT8WS card, so as not to have any metal or cement
obstructions.
- Fit the base ⑤ onto the chosen surface with suitable nuts
and bolts.
- Fit the control card ⑩ into the casing ⑨.
- Fasten with the supplied screw ⑦.
- Resistive, sensitive-safety edges: connect the
DFWN-series edges to the IN1 or IN2 terminals, and cut
out the resistor as shown ⑪.
- NON-resistive, sensitive-safety edges: connect the
DF-series edges to the IN2 or IN1 terminals, and add the
supplied 8.2 kΩ resistor as shown ⑫.
- Save the RIOED8WS wireless module to the RIOCT8WS or
the RIOCN8WS card (see the chapter on SAVING).
- Make the necessary functional checks (see the RIOCT8WS
or the RIOCN8WS manual).
- Shut the casing by latching the top of the cover and fasten-
ing it with the supplied screw ⑥.
Saving
Fit the batteries into all accessories that will be saved.
⚠After three minutes, the devices shift into stand-by mode;
to reactivate them, press T1 or T2 for one second.
Check that the CH1 and CH2 LEDs are flashing red simulta-
neously, otherwise do a RESET (see THE RESETTING PRO-
CEDURE).
First T1 or T2 storage
Press, for one second, the T1 or T2 button on the RIOED8WS
card: the CH1 and CH2 LEDs will flash red in alternation.
Press, for one second, the PROG button on the RIOCN8WS
card or the RIOCT8WS card: the WIRELESS LEDs, on the
RIOCN8WS or the RIOCT8WS card, will switch from flashing
to o, and the CH1 LED on the RIOED8WS card will make a
quick blue flash to confirm the programming.
To add an additional IN1 or IN2 input to an already associa-
ted device, press exclusively the button related to the new
input added (IN1 = T1 IN2 = T2).
⚠ To stop the STORAGE procedure, press the RESET key
for one second at any time.
Resetting procedure
- Keep pressed the T2 button on for about 10 seconds on
the RIOED8WS card, until the CH1 and CH2 LEDs flash red.
☞ If you replace any device on the system, you will have
To Next Page
Loading...