Camo LEVER User Manual

How To Use the LEVER™
800-968-6245 • INFO@CAMOFASTENERS.COM • WWW.CAMOFASTENERS.COM
GRAND RAPIDS, MI 49519
WWW.NATIONALNAIL.COM
HOW TO ASSEMBLE
A - Straighten the handle.
B - Align both holes by
rotating the board cam.
1
Use supplied hex key to
securely tighten the screw.
3
Insert flathead screw from
the bottom of board cam.
2
A
B
BOARD CAM
CUSHIONED
NON-SLIP
HANDLE
PIVOT PIN
JOIST ADJUSTMENT
KNOB
2-SIDED
STOP BLOCK
JOIST CAM

Camo LEVER Specifications

General

Brand	Camo
Model	LEVER
Category	Power Tool
Language	English

Summary

How to Assemble the CAMO LEVER

Assemble Handle and Cam

Straighten the handle and align holes by rotating the board cam for proper assembly.

Secure Cam Assembly

Insert flathead screw from the bottom of the board cam and tighten it.

Final Tightening

Use the supplied hex key to securely tighten the screw, completing the assembly.

CAMO LEVER: Lock-in Grooved Boards & Clips

Set Joist Type and Width

Select joist material and adjust stop block for correct joist width.

Position and Lock LEVER

Place LEVER on joist, tighten cam with Pivot Pin, ready for fastening.

Apply Pressure and Fasten

Move handle towards deck board; leave LEVER until all clips are fastened.

Release and Remove LEVER

Move handle away from deck board to release pressure, then loosen cam and remove.

CAMO LEVER: Straighten Warped Boards

Set Joist Type and Width for Warped Boards

Select joist material and adjust stop block for correct joist width.

Position LEVER and Begin Bending

Place LEVER on joist, tighten cam, and apply pressure to start bending.

Close Gap and Fasten Board

Keep turning until board is positioned, leave LEVER until fastening is complete.

Release and Remove LEVER

Move handle away from deck board to release pressure, then loosen cam and remove.