Why is my CAMPAGNOLA Power Tool battery not fully charging?
Why isn't my CAMPAGNOLA Power Tool battery fully charging? It could be due to a degraded battery, a faulty battery charger, or using an unsuitable charger. Ensure you're using the charger supplied with the shear. If not, consider replacing either the battery or the battery charger.
What to do if the CAMPAGNOLA STARK L shear cannot complete the cut?
What to do if the CAMPAGNOLA Power Tool shear cannot complete the cut? It might be because the branch diameter is over 25 mm or the wood is too hard. Immediately release the trigger; the cutting blade will return to its open position.
What to do if my CAMPAGNOLA STARK L does not work?
What to do if my CAMPAGNOLA Power Tool doesn't work? It might be an electronic or mechanical problem, and you should contact an Authorized Service Point.
Why is my CAMPAGNOLA Power Tool malfunctioning electrically or mechanically?
Why is my CAMPAGNOLA Power Tool malfunctioning electrically or mechanically? This could be due to motor overheating or unusual noises. In this case, contact an Authorized Service Point.
Ensure batteries are fully charged before the initial operation.
Insert the battery into the designated port on the shear.
Press the on/off button; the display will light up with an audible beep.
Pull the trigger twice quickly to open blades and begin operation.
Hold the trigger until one beep is heard for 70% blade opening.
Hold the trigger until one beep is heard for 100% blade opening.
Press and hold the trigger for 3 seconds to close the blades.
Press the on/off button to turn off the shear.
Detach the battery and connect it to the charger.
Remove the battery before cleaning the shear and then clean the blades.
Apply lubricant to blades and all moving components twice daily.
General| Brand | CAMPAGNOLA |
|---|---|
| Model | STARK L |
| Category | Power Tool |
| Language | English |
To Next Page
