COMPONENTS
INSTALLATION OF THE INTERFACE UNIT V4 (INTERNAL)
INSTALLATION - Rev. 00/ 06-2019 1
WARNING!
THIS TECHNICAL MANUAL IS INTENDED FOR USE BY PROFESSIONAL MECHANICS.
Anyone who is not professionally qualied to assemble bicycles should not attempt to install and operate on the components because of the risk of carrying out incor-
rect operations that could cause the components to malfunction with the consequent risk of accidents, physical injury or even death.
The actual product may dier from what is illustrated, as the specic purpose of these instructions is to explain the procedures for using the component.
1 – COMPATIBILITY
WARNING!
This Interface Unit V4 is not compatible with Bar-End controls or Bar-End brake controls.
2 - INTERFACE WITH THE FRAME
2.1 - SPECIFICATIONS FOR FRAME INSTALLATION
Note: where not specied, all measurements are expressed in millimetres.
15,3
9
3,5
27
Ø 19
27,6
49
35,5
M3
36
1
To Next Page
Need help?
General