EasyManua.ls Logo

Campo Equipment ECOBlaze DF2500 - User Manual

Campo Equipment ECOBlaze DF2500
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CAMPO EQUIPMENT CO. LTD. (ECOBLAZE)
6 Carson Court, Brampton, ON, CANADA, L6T 4P8
Tel: (905) 793-2525 | Fax: (905) 793-8768 | www.campoequipment.com
pg. 1
NG/LP DIRECT FIRED SPACE HEATER: BLAZE DF2500
WWW.CAMPOEQUIPMENT.COM
REPORT # 0367GH009S
Installation Instructions-Manual-Maintenance-Parts List
CAUTION: DO NOT TAMPER WITH HEATER OR ITS CONTROLS. CALL A QUALIFIED SERVICE TECHNICIAN
Retain manual for future reference Sept 29, 2021
CERTIFIED FOR USE IN CANADA AND THE U.S.A.

Questions and Answers

  • P
    Pamela OwensAug 22, 2025
    Why Campo Equipment ECOBlaze DF2500 blower motor does not run?
    • R
      Raymond KerrAug 23, 2025
      If the blower motor of your Campo Equipment Heater isn't running, there could be several reasons. First, ensure the heater is receiving power by turning the breaker and safety switch ON. Insufficient voltage could also be the cause, so check the incoming power supply. Inspect the wiring for any disconnections, looseness, or breaks; connect, tighten, or replace wiring connections as needed. The main switch might be OFF or defective, so turn the control toggle switch ON or replace the switch. Finally, a defective VFD could be the issue; check to see if there is power to the VFD.
  • R
    Robert FloresSep 1, 2025
    What to do if Campo Equipment ECOBlaze DF2500 Heater burner stops during usage?
    • K
      Karen HaleSep 1, 2025
      If your Campo Equipment Heater burner stops during use, it could be due to the heater overheating. Check to see if the modulating valve is not stuck. Another cause might be an interruption in power; in this case, restore power to the unit.
  • W
    williamsbrandyNov 10, 2025
    What to do if Campo Equipment ECOBlaze DF2500 Heater burner does not ignite?
    • J
      Johnny WatsonNov 11, 2025
      If the burner on your Campo Equipment Heater fails to ignite, several factors could be at play. Start by checking the incoming voltage to ensure it's sufficient. Then, inspect the electrode for any disconnections, incorrect adjustments, or defects; connect, adjust, or replace it as needed. Also, examine the Air Proving Switch for disconnections or defects, and connect or replace it if necessary. Ensure the Tilt switch is connected, the unit is on a level surface, and that the switch isn't defective; connect or replace the switch, or level the unit. Check if the Fan Overheat switch is open, and see if the unit is running on low voltage or if the fan is overheating. If the overheat light is on, press the overheat reset push button. Ensure sufficient gas delivery by filling the tank, opening ...

Campo Equipment ECOBlaze DF2500 Specifications

General IconGeneral
BrandCampo Equipment
ModelECOBlaze DF2500
CategoryHeater
LanguageEnglish

Related product manuals