EasyManuals Logo

CAN CHECKED MFD28 Gen2 Quick Start Guide

CAN CHECKED MFD28 Gen2
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
The setup
Once you have swiped down from the top of your display and pressed "Setup", you will reach
the sub-items described below. Depending on the acve protocol some menu funcons are
locked ( ).
Popup Switching the pop-up window on and o when limit values are
exceeded or undershot by means of a large, unmissable warning on
the display. ATTENTION: Must be congured in advance in the Display-
SetupSoware (DSS) for each sensor. The duraon can be congured
by tapping on the me.
Can Bus
Tap this menu to select the TRX/TRI le or to make Can Bus sengs.
If you have purchased a vehicle-specic display, everything is already
pre-congured.
Sensor Init Important sensors for operang the display: RPM → RPM; Speed →
Speed; Gear → Gear/GearCalc; Gear Mode → Gear Mode (automac
only) all others please set to N/A
Changes get applied aer a gauge restart.
License Here you will nd the serial number, the soware version and the
opon of addional funcons.
Gears Conguraon of gear calculaon: Your display can calculate the current
gear from rpm and speed. For each gear the rao must be entered or
determined and entered during driving operaon. Please ensure that
the "Sensor Init" is correct.
Splash Screen Duraon of the start screen. When completely deacvated, your
display is ready for use in less than one second.
Start Page The number indicates the page that is displayed rst aer start-up.
Either 1-10 or "last used" - i.e. the page that was last used when the
display was turned o.
Shi Light Tap to change the colors or use the keypad to change the rev limit.
If you use the external shi light, you can customize it here.
Dim Sensivity Only for UDS rmware and BMW rmware: the higher the number,
the more the display is dimmed together with your speedometer. If you
see the yellow triangle with exclamaon mark here, this value is not
supported by your speedometer. However, you can use the brightness
slider (swipe the screen upwards during normal operaon).
Pages Here you will nd the "Widget Packs" for the corresponding number of
cylinders, you can hide unnecessary pages, switch the eding of pages
on and o and change the orientaon of the user interface of your
display.
Custom Buon Here you can dene the buon in the lower menu (swipe screen
upwards).
3

Other manuals for CAN CHECKED MFD28 Gen2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CAN CHECKED MFD28 Gen2 and is the answer not in the manual?

CAN CHECKED MFD28 Gen2 Specifications

General IconGeneral
BrandCAN CHECKED
ModelMFD28 Gen2
CategoryMonitor
LanguageEnglish