Installation, use and maintenance instruction manual ▪ Ed. 05/2018 Rev. 00
SAFETY WARNINGS DURING USE
ATTENTION!
During operation and for a few minutes after use, some parts of the appliance reach very high
temperatures. Do not touch these parts without adequate personal protections. Burn hazard!
▪ Always use the supplied pan supports. Do not place pots and pans directly on the burner spreader
or caps.
▪ Do not cook food in direct contact with the flame.
▪ Do not cover the appliance or parts of it with aluminium foil or similar.
▪ Do not heat tin boxes or hermetically closed containers on the appliance as the overpressure generated
by the heat could make them explode and cause serious personal harm.
▪ Make sure that the cooking vessels sit properly on the pan support without rocking. The diameter of
the vessels must be adequate for the chosen burner and must not protrude from the pan support. The
Manufacturer will not be held liable and will not acknowledge the Warranty rights if this requirement
is neglected.
▪ Always monitor the appliance during its entire operation.
▪ Switch off the burner after each use.
▪ Do not set or keep flammable liquids or materials or objects which can easily catch fire on the appliance
or in its immediate vicinity.
▪ Do not place hot pans on the controls.
▪ Do not light the burner without pans and/or with empty pans.
ATTENTION!
If cooking grease or hot oil catches fire, do not put out the flames with water, but suffocate
them with a moist rag or similar and immediately notify the fire brigade.
USE
Before using the appliance for the first time, clean it and all of its components as instructed
in the paragraph “Cleaning”.
The first few times the appliance is used, it could emit smoke and unpleasant smells.
There is no reason for concern as this is due to the combustion of the grease used to process it in the
factory. We recommend airing out the rooms.
The burners are equipped with safety thermocouple.
The thermocouple is a heat sensitive device: as long as it is heated by the fire of the lit burner, it
allows gas to exit the nozzle; if the fire goes out accidentally (for example when liquid spills from
the pan), in a few seconds the thermocouple cools off and this blocks the exit of gas from the
nozzle preventing the room from being saturated with unburnt gas.
To Next Page
Loading...