CanadianSolar CS6W-TB-AG User Manual

For professional use only
INSTALLATION MANUAL
OF PHOTOVOLTAIC
MODULE

CanadianSolar CS6W-TB-AG Specifications

General

Model	CS6W-TB-AG
Manufacturer	Canadian Solar
Cell Type	Monocrystalline
Power Tolerance	0 ~ +5 W
Temperature Coefficient of Isc	+0.05%/°C
Frame	Anodized aluminum alloy
Connector	MC4 Compatible
Maximum System Voltage	1500V DC
Operating Temperature Range	-40°C ~ +85°C
Front Glass	3.2 mm tempered glass
Junction Box	IP68, 3 bypass diodes
Warranty	12 year product warranty / 25 year linear power output warranty

Summary

2 SAFETY PRECAUTIONS

3 MECHANICAL / ELECTRICAL SPECIFICATIONS

5 MODULE INSTALLATION

5.1 MODULE WIRING

Provides instructions and diagrams for correctly wiring photovoltaic modules in a system.

AVOID SHADING

5.2 GROUNDING

6 MOUNTING INSTRUCTIONS

6.1 MOUNTING METHOD: BOLTING

Explains the approved bolting methods for module installation, including torque specifications and hole locations.

6.2 MOUNTING METHOD: CLAMPING

6.2.1 Clamp mounting on long side of frame and rails perpendicular to the long side frame

Details clamp mounting on the long side with rails perpendicular to it, specifying ranges and loads.

6.2.2 Clamp mounting on short side of frame and rails perpendicular to the long side frame

Details clamp mounting on the short side with rails perpendicular to it, specifying ranges and loads.

6.2.3 Clamp mounting on long side of frame and rails parallel to the long side frame

6.2.4 Four clamps on short side of frame and rails parallel to the long side frame

6.2.5 Six clamps on long side of frame and rails perpendicular to the long side frame

6.2.6 Two clamps on the long side and two clamps on the short side of frame. Rails run perpendicular to the long side frame

6.2.7 Four clamps mounting on short side of frame

6.2.8 Four clamps mounting on short side of frame, and an additional support bar placed below the center of the module

6.2.9 Rail-less clamping

Describes rail-less clamping methods for single glass monofacial modules, including overlap and load specifications.

6.3 INSERTION SYSTEM

6.4 MOUNTING METHOD: SINGLE-AXIS TRACKER

7 MAINTENANCE

8 MODULE CLEANING GUIDELINES

ANNEX C: COASTAL AREA ANTI-CORROSION INSTALLATION GUIDELINES