Need help?Do you have a question about the C&K systems 236i/L and is the answer not in the manual?
General| Brand | C&K systems |
|---|---|
| Model | 236i/L |
| Category | Security System |
| Language | English |
Details nominal loop voltages, resistance values, and electrical commonality for system operation.
Specifies battery requirements, transformer ratings, and output current limits for connected devices.
Explains connections for standby battery, mains power, sirens, and strobes.
Covers addressing Alpha and LED keypads and basic setup procedures.
Describes how to start programming the panel using keypads.
Specifies transformer connection, voltage, VA rating, and precautions for mains power supply.
Details output voltage, current limits, and behavior for sirens, strobes, and auxiliary devices.
Details the process of assigning unique addresses to Alpha and LED keypads.
Describes the initial keystrokes to enter programming mode using the installer combination.
Details the 6-digit installer combination for system programming and security.
Explains how to set up Personal Identification Numbers (PINs) for up to 6 users.
Configures reporting codes for different event types like shunts, restores, and status.
Sets up reporting codes for opening and closing events, specifying receiver selection.
Defines reporting codes for system status events like watchdog reset and communication failures.
Sets programmable entry and exit delay times for arming and disarming sequences.
Lists commands applicable to both LED and Alpha II keypads for system functions.
Lists commands reserved for installers, such as programming and keypad testing.
To Next Page