C&M Britony FlexiFlu - INSTALLING THE APPLIANCE

7
L
N
FROST THERMOSTAT
FAN
N
LOW
HIGH
HIGH
L
OW
NO FLOW
WATERFLOW
MICRO-SWITCH
2A
PRESSURE SWITCH

N
RL1

N
RL2
PRINTED CIRCUIT BOARD
THERMOCOUPLE
THERMOELECTRIC
VALVE
OOPPEERRAATTIIOONNAALL DDIIAAGGRRAAMM
FFiigg.. 44
33.. IINNSSTTAALLLLIINNGG TTHHEE AAPPPPLLIIAANNCCEE
A vertical flat area is required for the appliance : 1006 mm high x 445 mm wide (39.6 in x 17.5 in). The surface
on which the appliance is mounted must be of a non combustible material.
33..11 PPaacckkaaggiinngg
The appliance is attached to the wall via the mounting bracket and two bottom screw fixings. The appliance is pac
-
ked in a single car
ton. Remove contents fr
om car
ton and check against list.
11))
APPLIANCE - Assembled with trims.
22))
FLUE ASSEMBLY : a) Air inlet duct complete with terminal.
b) 2nd section flue duct (inside air inlet duct).
c) Flue turr
et with 1st section flue duct fitted.
d) Plastic turret cover.
33))
ACCESSOR
Y BOX
- containing :
-mounting bracket
- flue locking ring and ‘0’ ring seal
- 2 gaskets
- 4 wall mounting screws
- 4 turret fixing screws
- 2 turret cover fixing screws
- 1 gas control knob
- 1 temperatur
e selector knob
- gas service tap assy (not supplied with LPG models)
- water service tap assy